Three families, one question: can this drawing be made reliably?
Each family below is organised the way a buyer evaluates it — what the process can hold, what decides the compound, and what we need before quoting. Nothing here is a catalogue of stock sizes.
Custom EPDM Gaskets
Compression and transfer moulded seals for enclosures, pumps, HVAC and outdoor equipment. Weather, ozone and water resistance.
Anti-Vibration Mounts
Rubber-to-metal bonded mounts for pumps, compressors, gensets and machinery. Load, frequency and environment decide the design.
Extruded Profiles & Seals
Continuous EPDM, silicone and TPE profiles — bulb, lip, D-section, hollow and cord — cut to length or spliced into frames.
How to choose between them
The decision is usually made by geometry and volume, not by material preference.
| If the part is | Process | Typical volume logic | What decides cost |
|---|---|---|---|
| Flat or shaped seal, compressed between two faces | Compression or transfer moulding | Tooling justified from a few hundred pieces upward, depending on cavity count | Cavity count, tolerance class, deflashing and secondary operations |
| Long, constant cross-section | Extrusion, cut to length | Low tooling, economical from short runs upward | Die cost, cut length tolerance, splicing and end finishing |
| Rubber bonded to metal or plastic | Bonded moulding, over-moulding | Tooling plus substrate preparation | Substrate machining, bond area, primer system, test regime |
| Rigid housing or insert | Engineering-plastic moulding or machining, through a qualified partner | Depends on tool life and material | Mould cost, shrinkage, warp control and partner tooling ownership |
Buyer questions
Can you quote a part that mixes rubber and plastic?
Yes, where a rigid substrate carries a soft seal. Bonded and over-moulded assemblies are quoted per part: feasibility depends on substrate material, bond area and the moulding route, and it is confirmed before tooling rather than assumed.
How do I know which family my part belongs to?
Send the drawing and the operating conditions. If the part is a flat or shaped seal compressed between two faces it is usually moulded; if it is a long constant cross-section it is extruded; if it isolates vibration it is a bonded mount. Where a part spans two families we say so before quoting.
Do you supply standard parts as well as custom ones?
The focus here is custom parts made to a drawing. Where a standard profile or O-ring size fits, we will say so rather than sell a new tool - a standard part is usually cheaper and faster for the buyer.